AEI Security & Communications DGHDP1 Manuel d'instructions télécharger pdf (Page 28)

Page 28 Please read the instructions carefully prior to installation

DGHDP1 - DigiSender® HD Pro - Single Input Powerline AV Sender System

(EN) ENGLISH

Information & Safety

Important Product Information & Abnormal Operation

Important Product Information

Power Line Communication or Power Line Carrier (PLC), are systems for carrying data on a conductor also

used for electrical power transmission.

The Transmitter and Receiver units must be operating on the same AC power circuit for guaranteed performance.

This product may not perform efﬁciently if plugged into Power Strips (especially those with Surge Protection and

EMI / RFI Filtration) or Extension Cords. For best results it is recommended that you connect the units directly

to a mains power socket. In homes with multiple mains circuits installed, it is recommended that both units are

installed on the same circuit so that they can communicate effectively with each other.

Power sockets and electrical wiring must all be part of the same electrical system. Certain electrical conditions in

your home, such as wiring conditions and conﬁguration, may affect the performance of this product.

Note: Interference from devices that emit electrical noise, such as vacuum cleaners, refrigerators, hair dryers, old

electric motors and poor quality mobile phone chargers for example, may adversely affect the performance of this

product. This product may have the possibility to interfere with devices such as lighting systems that have a dim-

mer switch, short wave radios, or other power line devices that do not follow the correct wiring standard.

Abnormal Operation

• It will take 30 to 40 seconds to establish a connection between the transmitter and receiver. If

there is no signal coming through to the receiver after this time, please try the Syncing the Trans-

mitter & Receiver procedure on page 18 and refer to the troubleshooting section of this manual. If

you are unable to resolve your problem, please contact our support helpline on 0207 193 1413.

• If a unit is accidentally exposed to water or the case is damaged in any way, you should im-

mediately turn the unit off at the mains and disconnect the plug. The unit should be replaced at

the next available opportunity, failure to do so could result in an electrical short or ﬁre. If you are

uncertain of your situation, please call our support hotline on 0207 193 1413.

• If any smoke or odors emanate from the units, you should immediately turn the unit off at the

mains and disconnect the plug. Continuing to use this product in these conditions could cause a

ﬁre or damage the product irreparably. Please call our support hotline on 0207 193 1413.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 111 112

Pas de commentaire

AEI Security & Communications DGHDP1 Manuel d'instructions Page 28